HP StorageWorks HSG80 ACS Solution Software V8.8 for Linux X86 Installation and Configuration Guide (AA-RV1LA-TE, March 2005)

Planning a Subsystem
38 HSG80 ACS Solution Software V8.8 for Linux X86 Installation and Configuration Guide
The CCL does the following:
■ Allows the RAID Array to be recognized by the host as soon as it is attached
to the SCSI bus and configured into the operating system.
■ Serves as a communications device for the HS-Series Agent. The CCL
identifies itself to the host by a unique identification string.
In dual-redundant controller configurations, the commands described in the
following sections alter the setting of the CCL on both controllers. The CCL is
enabled only on host port 1.
Determining the Address of the CCL
CCL is enabled by default. Its address can be determined by entering the
following CLI command:
HSG80 > SHOW THIS_CONTROLLER
Enabling/Disabling the CCL in SCSI-2 Mode
Enabling the CCL
To enable the CCL, enter the following CLI command:
HSG80 > SET THIS_CONTROLLER COMMAND_CONSOLE_LUN
Disabling the CCL
To disable the CCL, enter the following CLI command:
HSG80 > SET THIS_CONTROLLER NOCOMMAND_CONSOLE_LUN
To see the state of the CCL, use the SHOW THIS CONTROLLER/ OTHER CONTROLLER
command. Because the CCL is not an actual LUN, the
SHOW UNITS command does
not display the CCL location.
Enabling/Disabling CCL in SCSI-3 Mode
The CCL is enabled all the time. There is no option to enable/disable.
Determining Connections
The term “connection” applies to every path between a Fibre Channel adapter in a
host computer and an active host port on a controller.