HP StorageWorks HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide (AA-RV1HA-TE, March 2005)

FC Configuration Procedures
137HSG80 ACS Solution Software V8.8 for IBM AIX Installation and Configuration Guide
Configuring Controller Settings
3. Set the SCSI version using the following command syntax:
SET THIS SCSI_VERSION=SCSI-2, or
SET THIS SCSI_VERSION=SCSI-3
Note: If SCSI-2 is selected, you must disable CCL using the command:
SET THIS NOCOMMAND_CONSOLE_LUN
Note: HP recommends that SCSI-3 mode be used.
4. Check the configuration (parameter settings) of your controller against those
listed in Table 14, which are the correct HSG80 controller parameter settings
for an IBM-AIX environment.
Setting This Controller
5. To set the prompt to the HSG80 controller, enter:
SET THIS_CONTROLLER PROMPT=”HSG>”
Table 14: Correct controller parameter settings
HSG80 Parameter
Settings for:
Loop Fabric
Prompt HSG80> HSG80>
Node (WWN) nnnn-nnnn-nnnn-nnnn nnnn-nnnn-nnnn-nnnn
Command Console LUN Enabled Enabled
Port 1 Topology LOOP HARD FABRIC
Port 2 Topology LOOP HARD FABRIC
Port 1 ALPA D5 N/A
Port 2 ALPA D6 N/A
SCSI Version SCSI-2 or SCSI-3 SCSI-2 or SCSI-3
New Connection OS Type AIX_CAMBEX AIX_CAMBEX