HP DDS/DAT tape drives UNIX, Linux and OpenVMS configuration guide (DW049-90930, May 2010)

2. From the SMH Tools page, select Modules from the Kernel Configuration section:
Figure 3 SMH web-based interface (HP-UX11i v3)
.
3. In the Search box on the Kernel Configuration page, type stape and execute the search. The
search results list will include both estape and stape modules. If either of these modules is not
installed both Current State and Next Boot State will be shown as “unused”. A state of “static”
indicates that the module is installed.
4.
Select the estape module
3
radio button. Its details will appear in a panel below the modules
list. From the right hand panel on the web page, click the Modify Module link.
5. On the Modify Kernel Module: estape page, for Next Boot State, select the “static” radio button.
Check the box entitled Backup to create a backup copy of the existing kernel:
Figure 4 Adding estape driver to the kernel
.
3
The estape and stape modules are linked, so it is sufficient to select the estape module alone for installation.
UNIX, Linux and OpenVMS configuration guide 11