HP StorageWorks Fabric OS 5.x MIB Reference Guide (AA-RVHXB-TE, September 2005)

164 SW MIB objects
swFCPortLipOuts
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.32
Description Counts the number of loop initializations that have been initiated by the port.
swFCPortLipLastAlpa
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.33
Description Indicates the arbitrated-loop physical address (AL_PA) of the loop device that initiated the
last loop initialization.
swFCPortWwn
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.34
Description The WWN of the Fibre Channel port. The contents of an instance are in IEEE extended
format, as specified in FC-PH.
swFCPortSpeed
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.35
Description The desired baud rate for the port.
Note The baud rate can be 1 Gbit/sec, 2 Gbit/sec, or 4 Gbit/sec. 4 Gbit/sec is applicable
only to the SAN Switch 4/32.
swFCPortName
Supported in Fabric OS 4.1.x and later.
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.36
Description A string that indicates the name of the addressed port.
The names should be persistent across switch reboots. Port names do not have to be
unique within a switch or within a fabric.
swFCPortSpecifier
Syntax DisplayString
Access read-only
Status current
Description This string indicates the physical port number of the addressed port.
Note This string can be entered as argument on CLI commands such as portShow or wherever
a physical port number is expected.
The format of the string is: slot/port, where slot is present only for bladed systems.
Example for directors, such as 4/256 SAN Director:
swFCPortSpecifier.64 = 4/15
Example for non-bladed systems, such as SAN Switch 4/32:
swFCPortSpecifier.31 = 31