HP StorageWorks Fabric OS 5.x Fabric Watch Administrator Guide (AA-RVJ0B-TE, September 2005)

ManualsBrandsHP ManualsStorageHP StorageWorks Core Switch 2/64 power pack

Fabric OS 5.x Fabric Watch administrator guide 43

Figure shows how to select the custom settings for the threshold alarm level for the RXPerformance area.

The options are either to accept the default settings or provide custom settings.

Figure 10 Changing the threshold alarm level

Figure shows how to apply the custom value for the threshold alarm changes; unless you apply the value,

it does not take effect.

Figure 11 Applying threshold alarm changes

NOTE: To ensure that your alarm setting configuration is in effect, remember to change the alarm level to

Custom and then apply the alarm settings.

1 : change behavior type 11 : change threshold alarm level

2 : change behavior interval 12 : change changed alarm

3 : change threshold boundary level 13 : change below alarm

4 : change custom unit 14 : change above alarm

5 : change custom time base 15 : change inBetween alarm

6 : change custom low 16 : apply threshold alarm changes

7 : change custom high 17 : cancel threshold alarm changes

8 : change custom buffer 18 : return to previous page

9 : apply threshold boundary changes

10 : cancel threshold boundary changes

Select choice => : (1..18) [18] 11

1 : Default

2 : custom

Enter alarm level type => : (1..2) [1] 2

Index ThresholdName BehaviorType BehaviorInt

8 eportRXPerf008 Triggered 1

17 eportRXPerf017 Triggered 1

26 eportRXPerf026 Triggered 1

27 eportRXPerf027 Triggered 1

28 eportRXPerf028 Triggered 1

29 eportRXPerf029 Triggered 1

Threshold boundary level is set at : Custom

Default Custom

Unit Percentage(%) Percentage(%)

Time base minute minute

Low 0 0

High 100 80

BufSize 0 0

Threshold alarm level is set at : Custom