HP StorageWorks Fabric OS 5.x Fabric Watch Administrator Guide (AA-RVJ0B-TE, September 2005)

Fabric OS 5.x Fabric Watch administrator guide 37
4. advanced configuration
To customize Fabric Watch monitoring to suit to your environment, use the advanced configuration
option as follows:
1. Enter 4 at the command prompt.
The system generates output similar to the following screen. The output you see varies based on the class
and area you select. In the Advanced Configuration menu shown here, the output is based on the E-Port
class and RXPerformance area.
NOTE: To ensure that your threshold setting configuration takes effect, remember to change the threshold
boundary level to Custom using option 3, and then apply the threshold boundary level settings using
option 16.
Table 13 describes the event behavior of each element in the Advanced Configuration menu.
1 : refresh
2 : disable a threshold
3 : enable a threshold
4 : advanced configuration
5 : return to previous page
Select choice => : (1..5) [5] 4
Index ThresholdName BehaviorType BehaviorInt
8 eportRXPerf008 Triggered 1
17 eportRXPerf017 Triggered 1
26 eportRXPerf026 Triggered 1
27 eportRXPerf027 Triggered 1
28 eportRXPerf028 Triggered 1
29 eportRXPerf029 Triggered 1
Threshold boundary level is set at : Default
Default Custom
Unit Percentage(%) Percentage(%)
Time base minute minute
Low 0 0
High 100 0
BufSize 0 0
Threshold alarm level is set at : Default
Errlog-1, SnmpTrap-2, PortLogLock-4
RapiTrap-8, EmailAlert-16
Valid alarm matrix is 31
Default Custom
Changed 0 0
Below 0 0
Above 0 0
InBetween 0 0
1 : change behavior type 11 : change threshold alarm level
2 : change behavior interval 12 : change changed alarm
3 : change threshold boundary level 13 : change below alarm
4 : change custom unit 14 : change above alarm
5 : change custom time base 15 : change inBetween alarm
6 : change custom low 16 : apply threshold alarm changes
7 : change custom high 17 : cancel threshold alarm changes
8 : change custom buffer 18 : return to previous page
9 : apply threshold boundary changes
10 : cancel threshold boundary changes
Select choice => : (1..18) [18]