HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 99
AUTH-1013
Message
Probable Cause
Indicates that the system is running low on resources when receiving an authentication request.
Recommended Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
AUTH-1014
Message
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1017
Message
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
<timestamp>, [AUTH-1013], <sequence-number>,, WARNING,
<system-name>, Can not perform authentication request message: port
<port number>, message code <message code>
<timestamp>, [AUTH-1014], <sequence-number>,, ERROR, <system-name>,
Invalid port value to <operation>: port <port number>
<timestamp>, [AUTH-1017], <sequence-number>,, ERROR, <system-name>,
Invalid value to start authentication request: port <port number>,
opcode <operation code>