HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 97
Recommended Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1007
Message
Probable Cause
Indicates that the proposed authentication protocol type or types are not supported by the local port.
Recommended Action
Run the authUtil command to make sure the local switch supports the specified protocols: FCAP or
DH-CHAP.
Severity
ERROR
AUTH-1008
Message
Probable Cause
Indicates that the switch does not have a security license.
Recommended Action
Verify that the security license is installed using the licenseShow command. If necessary, reinstall the
license using the licenseAdd command.
Severity
ERROR
AUTH-1010
Message
<timestamp>, [AUTH-1007], <sequence-number>,, ERROR, <system-name>,
The proposed authentication protocol(s) are not supported: port
<port number>.
<timestamp>, [AUTH-1008], <sequence-number>,, ERROR, <system-name>,
No security license, operation failed.
<timestamp>, [AUTH-1010], <sequence-number>,, ERROR, <system-name>,
Failed to initialize security policy: switch <switch number>, error
<error code>.