HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 409
ZONE-1029
Message
Probable Cause
Indicates that the zone configuration restored from the flash was faulty.
Recommended Action
This error will save the faulty zone configuration in the zoned core file directory. Run the saveCore
command to save the file.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
ZONE-1030
Message
Probable Cause
Indicates that the current zone database could not be converted to reflect the PID format change. Most
likely this is caused by the size of the zone database.
Recommended Action
Change the PID format back to its original format. Reduce the size of the zone database. Then you can
change the PID format to the requested format.
Severity
WARNING
ZONE-1031
Message
Probable Cause
The switch is set to interop mode using the interopMode command. Interop mode does not allow
<domain, portarea> members in the active zone database.
Recommended Action
Remove all <domain, portarea> members from the zone database, or convert them to WWN zoning.
<timestamp>, [ZONE-1029], <sequence-number>,, WARNING,
<system-name>, Restoring zone cfg from flash failed - bad config
saved to <config file name> [<return code>]
<timestamp>, [ZONE-1030], <sequence-number>,, WARNING,
<system-name>, Converting the zone db for PID format change failed
<timestamp>, [ZONE-1031], <sequence-number>,, ERROR, <system-name>,
Switch is in interop mode. (switch, port) members not supported.