HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

406 Error messages
QuickLoop zones are not supported in Fabric OS v4.x.
Recommended Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
ZONE-1019
Message
Probable Cause
Indicates that the Reliable Commit Service (RCS) had a transmit error. RCS is a protocol used to transmit
changes to the configuration database within a fabric.
Recommended Action
Often this message indicates a transitory problem. Wait a few minutes and retry the command.
Make sure that your changes to the zone database are not overwriting the work of another admin.
Run the cfgTransShow command to find out if there is any outstanding transaction running on the local
switches.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
ZONE-1022
Message
Probable Cause
Indicates that the effective zone configuration has changed.
Recommended Action
Verify that this zone configuration change was done on purpose. If the new effective zone configuration is
correct, no action is necessary.
Severity
INFO
<timestamp>, [ZONE-1019], <sequence-number>,, ERROR, <system-name>,
Transaction Commit failed. Reason code <reason code> (<Application
reason>) - \"<reason string>\"
<timestamp>, [ZONE-1022], <sequence-number>,, INFO, <system-name>,
The effective configuration has changed