HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 401
ZONE Error Messages
ZONE-1002
Message
Probable Cause
Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a failure
when creating or adding zone groups during PLOGI trap processing. This messages usually indicates
problems when adding CAM entries before the filter setup.
Recommended Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
ZONE-1003
Message
Probable Cause
Indicates that the port zone member that is targeted for the local switch contains a non-existent port. The
effective zoning configuration (displayed in the error message) contains a port number that is out of range.
Recommended Action
Edit the zone database and change the port number to a viable value in the effective configuration.
Severity
WARNING
ZONE-1004
Message
Probable Cause
Indicates that the zoning enforcement changed to session-based hard zoning. When a device is zoned
using both WWN in one zone and <domain, portarea> in another, this will cause that port to go session
based hard zoning.
In session-based zoning, the zone enforcement is checked by the software. In hardware-enforced zoning,
zone or alias members are defined using <domain, portarea> exclusively or using WWNs exclusively: that
<timestamp>, [ZONE-1002], <sequence-number>,, WARNING,
<system-name>, WWN zoneTypeCheck or zoneGroupCheck warning(<warning
string>) at port(<port number>)
<timestamp>, [ZONE-1003], <sequence-number>,, WARNING,
<system-name>, zone(<current zone>) contains (<domain id>, <port
number>) which does not exist.
<timestamp>, [ZONE-1004], <sequence-number>,, INFO, <system-name>,
port <port number> enforcement changed to Session Based HARD
Zoning.