HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 389
• PANICDUMP generated by panic dump
• WATCHDOG EXPIRED generated by hardware watchdog expiration
• MANUAL generated by the traceDump -n command
• TRIGGER when triggered by a specific Message ID generated by CRITICAL RASLog message or
RASLog message trigger setup using the traceTrig command
Recommended Action
Run supportFtp and traceFtp (as needed) to set up automatic FTP transfers; then run the supportSave
command and contact your switch service provider.
Severity
WARNING
TRCE-1002
Message
Probable Cause
Indicates that a trace dump has occurred on the switch or the indicated slot and is successfully transferred
from the switch automatically.
Recommended Action
No action is required.
Severity
INFO
TRCE-1003
Message
Probable Cause
Indicates that a trace dump has been created on the switch or the indicated slot but is not automatically
transferred from the switch due to an FTP error, such as wrong FTP address, FTP site down, or the network
is down.
Recommended Action
Verify that the FTP parameters specified in supportFtp are correct.
Verify that the FTP parameters specified in traceFtp are correct.
Verify that the switch is connected to your Ethernet network.
Verify that the your network is up and running.
Severity
ERROR
<timestamp>, [TRCE-1002], <sequence-number>,, INFO, <system-name>,
Trace dump< optional slot indicating on which slot the dump occurs >
automatically transferred to FTP address ' <FTP target designated
by user> '.
<timestamp>, [TRCE-1003], <sequence-number>,, ERROR, <system-name>,
Trace dump< optional slot indicating on which slot the dump occurs >
was not transferred due to FTP error.