HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 387
Probable Cause
Indicates that during system startup the option configuration file corresponding to the chassis config option
read could not be found. This indicates that the option is not supported on this platform running this version
of the command.
It could also indicate that the current option number could not be read form the chassis option storage
device (the WWN card).
This message only occurs on the SAN Director 2/128 and 4/256 SAN Director.
Recommended Action
Use the chassisConfig command to change chassis config mode to a setting that is valid for this platform
running this firmware level. Chassis config mode 1 is valid for all platforms running all levels of firmware.
Severity
CRITICAL
SYSM Error Messages
SYSM-1001
Message
Probable Cause
Indicates that the switch has run out of system memory.
Recommended Action
Run the memShow command to view the switch memory usage.
Reboot or power cycle the switch.
Run supportFtp and traceFtp (as needed) to set up automatic FTP transfers; then run the supportSave
command and contact your switch service provider.
Severity
CRITICAL
SYSM-1002
Message
Probable Cause
Indicates that a user has executed either the switchShutdown or switchReboot command. All
services are brought down for a logical switch.
Recommended Action
No action is required if the switchShutdown or switchReboot command was executed intentionally.
If the switchShutdown command was run, you must run the switchStart command to restart traffic on
the logical switch.
<timestamp>, [SYSM-1001], <sequence-number>,, CRITICAL,
<system-name>, No memory
<timestamp>, [SYSM-1002], <sequence-number>,, INFO, <system-name>,
<number>, Switch: <Switch number>