HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

384 Error messages
Recommended Action
Run the firmwareCommit command.
If this message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
INFO
SWCH Error Messages
SWCH-1001
Message
Probable Cause
Indicates that the switch is enabled before it is ready.
Recommended Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
SWCH-1002
Message
Probable Cause
Indicates that the device is not present in the authorized profile list.
Recommended Action
Verify that the device is authorized to log in to the switch. If the device is authorized, run the
secPolicyDump command to verify whether the specified device WWN is listed. If it is not listed, run the
secPolicyAdd command to add this device to an existing policy.
Severity
INFO
SWCH-1003
Message
<timestamp>, [SWCH-1001], <sequence-number>,, ERROR, <system-name>,
Switch is not in ready state - Switch enable failed switch status=
0x<switch status>, c_flags = 0x<switch control flags>
<timestamp>, [SWCH-1002], <sequence-number>,, INFO, <system-name>,
Security violation: Unauthorized device <wwn name of device> tries
to flogin to port <port number>
<timestamp>, [SWCH-1003], <sequence-number>,, ERROR, <system-name>,
Slot ENABLED but Not Ready during recovery, disabling slot = <slot
number>(<return value>)