HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

382 Error messages
"Firmwarecommit has started on Standby CP." 0x77
"Firmwarecommit has completed successfully on Standby CP." 0x78
"Standby CP booted up with new firmware." 0x79
"Standby CP failed to boot up with new firmware." 0x7a
"Firmwarecommit has started on both Active and Standby CPs." 0x7b
"Firmwarecommit has completed successfully on Active CP." 0x7c
"Firmwarecommit failed on Active CP." 0x7d
"The original firmware has been restored successfully on Standby CP." 0x7e
"Unable to restore the original firmware on Standby CP." 0x7f
"Standby CP reboots." 0x80
"Standby CP failed to reboot." 0x81
"Standby CP booted up with new firmware." 0x82
"Standby CP failed to boot up with new firmware." 0x83
"There was an unexpected reboot during firmwareDownload. The
command is aborted."
0x84
"Standby CP was not responding. The command is aborted." 0x85
"Firmwarecommit has started on both CPs. Please use firmwaredownloadstatus
and firmwareshow to see the firmware status."
0x86
"Firmwarecommit has started on the local CP. Please use
firmwaredownloadstatus and firmwareshow to see the firmware status."
0x87
"Firmwarecommit has started on the remote CP. Please use
firmwaredownloadstatus and firmwareshow to see the firmware status."
0x88
"Please use firmwaredownloadstatus and firmwareshow to see the firmware
status."
0x89
"Firmwaredownload command has completed successfully." 0x8a
"The original firmware has been restored successfully." 0x8b
"Remote CP is restoring its secondary partition." 0x8c
"Local CP is restoring its secondary partition." 0x8d
"Remote CP is restoring its secondary partition." 0x8e
"Firmwaredownload has started." 0x8f
"Firmwarecommit has started." 0x90
"Firmwaredownload has completed successfully." 0x91
"Firmwarecommit has completed successfully." 0x92
"Firmwarecommit has started to restore the secondary partition." 0x93
"Firmwarecommit failed." 0x94
"The secondary partition has been restored successfully." 0x95
Table 5 Upgrade messages and code values (continued)
Upgrade messages Code