HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

366 Error messages
Severity
INFO
SEC-1302
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
INFO
SEC-1303
Message
Probable Cause
Indicates that the currently installed software version does not support the HP StorageWorks Secure Fabric
OS feature.
Recommended Action
Run the firmwareDownload command to update the firmware to the latest version for your specific
switch. Verify that the firmware you are installing supports the HP StorageWorks Secure Fabric OS feature.
Severity
INFO
SEC-1304
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
<timestamp>, [SEC-1302], <sequence-number>,, INFO, <system-name>,
This switch does not have all the required PKI objects correctly
installed.
<timestamp>, [SEC-1303], <sequence-number>,, INFO, <system-name>,
This software version does not support security.
<timestamp>, [SEC-1304], <sequence-number>,, INFO, <system-name>,
This switch has no security license.