HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 365
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
SEC-1253
Message
Probable Cause
Indicates that an internal error has caused the DCC policy update to fail in the provision, commit, or
cancel phases.
Recommended Action
Retry the failed security command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
SEC-1300
Message
Probable Cause
Indicates that the switch is set up with VC-encoded mode.
Recommended Action
Turn off VC-encoded mode before enabling security.
Severity
INFO
SEC-1301
Message
Probable Cause
Indicates that the switch is interop-mode enabled.
Recommended Action
Disable interop-mode using the interopMode command before enabling the Secure Fabric OS feature.
<timestamp>, [SEC-1253], <sequence-number>,, ERROR, <system-name>,
Bad DCC interface state during <Phase>, state=<state>.
<timestamp>, [SEC-1300], <sequence-number>,, INFO, <system-name>,
This switch is in VcEncode mode. Security is not supported.
<timestamp>, [SEC-1301], <sequence-number>,, INFO, <system-name>,
This switch is in interop mode. Security is not supported.