HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 353
Recommended Action
Verify that the security event was planned. If the security event was planned, retry FCS failover after current
failover has completed, if this switch should become primary FCS. If the security event was not planned,
take appropriate action as defined by your enterprise security policy.
Severity
ERROR
SEC-1168
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1170
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
INFO
<timestamp>, [SEC-1168], <sequence-number>,, ERROR, <system-name>,
Primary FCS failover is busy. Please retry later.
<timestamp>, [SEC-1170], <sequence-number>,, INFO, <system-name>,
This command must be executed on the Primary FCS switch, the first
reachable switch in the FCS list.