HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

352 Error messages
Recommended Action
Add the switch into the FCS policy list when using the lockdown option to enable security.
Severity
ERROR
SEC-1165
Message
Probable Cause
Indicates that the system is low on memory.
Recommended Action
Wait a few minutes and try the command again.
Severity
ERROR
SEC-1166
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1167
Message
Probable Cause
Indicates that because another failover is already in progress, this failover attempt cannot proceed.
<timestamp>, [SEC-1165], <sequence-number>,, ERROR, <system-name>,
Low memory, failed to enable security on all switches.
<timestamp>, [SEC-1166], <sequence-number>,, ERROR, <system-name>,
Non FCS tries to commit failover.
<timestamp>, [SEC-1167], <sequence-number>,, ERROR, <system-name>,
Another FCS failover is in process. Command terminated.