HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 351
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
INFO
SEC-1160
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
INFO
SEC-1163
Message
Probable Cause
Indicates that the lockdown option was attempted while the fabric is already in secure mode.
Recommended Action
Do not use lockdown option with secModeEnable, when switch is already in secure mode.
Severity
ERROR
SEC-1164
Message
Probable Cause
Indicates that the attempt to enable security is made on a switch that is not present in the FCS list.
<timestamp>, [SEC-1160], <sequence-number>,, INFO, <system-name>,
Duplicate port <Port ID> in port list (<Port list>).
<timestamp>, [SEC-1163], <sequence-number>,, ERROR, <system-name>,
System is already in secure mode. Lockdown option cannot be applied.
<timestamp>, [SEC-1164], <sequence-number>,, ERROR, <system-name>,
Lockdown option cannot be applied on a non-FCS switch.