HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 349
SEC-1154
Message
Probable Cause
Indicates that either the defined or the active policy could not be updated. If the policy database is very
large, it might not be able to change the area because the new policy database exceeds the maximum
size. This message can also be caused when the switch is short of memory. The status values can be either
defined, active, or both. A negative value means that a policy set was failed by the daemon.
Recommended Action
Reduce the size of the policy database.
Severity
INFO
SEC-1155
Message
Probable Cause
Indicates that either the defined or active policy was too large after modifying the area ID. The status
values can be either defined, active, or both. A negative value means that a policy set was failed by the
daemon.
Recommended Action
Reduce the size of the specified policy database.
Severity
INFO
SEC-1156
Message
Probable Cause
Indicates that the security daemon is busy. The status values can be either defined, active, or both. A
negative value means that a policy set was failed by the daemon.
Recommended Action
For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands might take
a few minutes to propagate throughout the fabric. Make sure to wait a few minutes between executing
commands so that your commands do not overlap in the fabric.
<timestamp>, [SEC-1154], <sequence-number>,, INFO, <system-name>,
PID change failed: <Reason> <defined status> <active status>.
<timestamp>, [SEC-1155], <sequence-number>,, INFO, <system-name>,
PID change failed: <Reason> <defined status> <active status>.
<timestamp>, [SEC-1156], <sequence-number>,, INFO, <system-name>,
Change failed: <Reason> <defined status> <active status>.