HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

340 Error messages
SEC-1106
Message
Probable Cause
Indicates that some PKI objects on the switch are not in a valid state, and a signature operation failed.
Recommended Action
Run the pkiShow command and verify that all PKI objects exist on the switch. If a failure to validate PKI
objects occurs, follow the steps for re-creating PKI objects outlined in the Secure Fabric OS User's Guide.
Severity
ERROR
SEC-1107
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
INFO
SEC-1108
Message
Probable Cause
Indicates that a version reset operation failed either because the switch could not get all the required
resources to perform the operation or because it failed to send the message to all switches in the fabric.
Recommended Action
Verify that the security event was planned. If the security event was planned, run the secFabricShow
command to verify that all switches in the fabric are in the ready state. When all switches are in the ready
state, retry the operation.
<timestamp>, [SEC-1106], <sequence-number>,, ERROR, <system-name>,
Failed to sign message data.
<timestamp>, [SEC-1107], <sequence-number>,, INFO, <system-name>,
Stamp is 0.
<timestamp>, [SEC-1108], <sequence-number>,, ERROR, <system-name>,
Fail to reset stamp on all switches.