HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 339
Probable Cause
Indicates that the switch failed to download certificate, security database, or policies. This can happen
when switch does not get enough resources to complete the operation, fabric has not stabilized, or policy
database is an invalid format.
Recommended Action
Wait for fabric to become stable and then retry the operation. If the policy database is in an illegal format
(with configDownload), correct the format and retry the operation.
Severity
ERROR
SEC-1104
Message
Probable Cause
Indicates that the switch failed to get either the primary certificate or a primary public key.
Recommended Action
Verify that the primary switch has a valid certificate installed and retry the operation. If a valid certificate is
not installed, install a certificate by following the procedure specified in the Secure Fabric OS User's
Guide.
Severity
ERROR
SEC-1105
Message
Probable Cause
Indicates that the switch failed to disable security in the fabric. This could happen if the switch cannot get
the required resources to complete the command, and sending to a remote domain fails or the remote
domain returns an error.
Recommended Action
Run the secFabricShow to verify that all switches in the fabric are in the ready state. Retry the command
when all switches are READY.
Severity
ERROR
<timestamp>, [SEC-1104], <sequence-number>,, ERROR, <system-name>,
Fail to get primary <Certificate or public key>.
<timestamp>, [SEC-1105], <sequence-number>,, ERROR, <system-name>,
Fail to disable secure mode on all switches.