HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 335
SEC-1091
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1092
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1093
Message
Probable Cause
Indicates that the new FCS list does not have a common member with the existing FCS list.
Recommended Action
Resubmit the command with at least one member of the new FCS list in common with the current FCS list.
<timestamp>, [SEC-1091], <sequence-number>,, ERROR, <system-name>,
No policy to remove.
<timestamp>, [SEC-1092], <sequence-number>,, ERROR, <system-name>,
<Policy name> Name not found.
<timestamp>, [SEC-1093], <sequence-number>,, ERROR, <system-name>,
New FCS list must have at least one member in common with current
FCS list.