HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 333
Recommended Action
No action is required.
Severity
ERROR
SEC-1085
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1086
Message
Probable Cause
Indicates that the security database has more data than the flash can accommodate.
Recommended Action
Reduce the number of entries in some policies to decrease the security database size.
Severity
ERROR
SEC-1088
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
<timestamp>, [SEC-1085], <sequence-number>,, ERROR, <system-name>,
Failed to create <Policy name>.
<timestamp>, [SEC-1086], <sequence-number>,, ERROR, <system-name>,
The security database is too large to fit in flash.
<timestamp>, [SEC-1088], <sequence-number>,, ERROR, <system-name>,
Cannot execute the command. Please try later.