HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

332 Error messages
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1082
Message
Probable Cause
Indicates that the security policy was not created due to faulty imput or low resources.
Recommended Action
Use proper syntax when creating policies. If the security database is too large, you must delete other
members within the database before adding new members to a policy.
Severity
ERROR
SEC-1083
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1084
Message
Probable Cause
Indicates that the specified policy already exists.
<timestamp>, [SEC-1082], <sequence-number>,, ERROR, <system-name>,
Failed to create <policy name> policy.
<timestamp>, [SEC-1083], <sequence-number>,, ERROR, <system-name>,
Name already exists.
<timestamp>, [SEC-1084], <sequence-number>,, ERROR, <system-name>,
Name exists for different type <Policy name>.