Manualshelf

HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

ManualsBrandsHP ManualsStorageHP StorageWorks Core Switch 2/64 power pack
331332333334335336337338339340
Fabric OS 5.x diagnostics and system error messages reference guide 331
Severity
ERROR
SEC-1079
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1080
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1081
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
<timestamp>, [SEC-1079], <sequence-number>,, ERROR, <system-name>,
Invalid policy name <Policy name>.
<timestamp>, [SEC-1080], <sequence-number>,, ERROR, <system-name>,
Operation denied. Please, use secModeEnable command.
<timestamp>, [SEC-1081], <sequence-number>,, ERROR, <system-name>,
DCC_POLICY is not allowed without a unique identifer.