HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

328 Error messages
SEC-1069
Message
Probable Cause
Indicates that the security database is corrupted for unknown reasons.
Recommended Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and
contact your switch service provider.
Severity
ERROR
SEC-1071
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1072
Message
Probable Cause
Indicates that the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and
contact your switch service provider.
Severity
ERROR
<timestamp>, [SEC-1069], <sequence-number>,, ERROR, <system-name>,
Security Database is corrupted.
<timestamp>, [SEC-1071], <sequence-number>,, ERROR, <system-name>,
No new data to apply.
<timestamp>, [SEC-1072], <sequence-number>,, ERROR, <system-name>,
<Policy type> Policy List is Empty!