HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

322 Error messages
Probable Cause
Indicates that the specified member is a duplicate in the input list. The list can be a policy list or a switch
member list.
Recommended Action
Do not specify any duplicates.
Severity
ERROR
SEC-1045
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1046
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
<timestamp>, [SEC-1045], <sequence-number>,, ERROR, <system-name>,
Too many port members.
<timestamp>, [SEC-1046], <sequence-number>,, ERROR, <system-name>,
Empty list.