HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 319
Recommended Action
Verify your member names, and input the correct information.
Severity
ERROR
SEC-1035
Message
Probable Cause
Indicates that the specified WWN is invalid.
Recommended Action
Enter the correct WWN value.
Severity
ERROR
SEC-1036
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1037
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
<timestamp>, [SEC-1035], <sequence-number>,, ERROR, <system-name>,
Invalid device WWN <Device WWN>.
<timestamp>, [SEC-1036], <sequence-number>,, ERROR, <system-name>,
Invalid device name <device name>. Missing colon
<timestamp>, [SEC-1037], <sequence-number>,, ERROR, <system-name>,
Invalid WWN format <Invalid WWN>.