HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

318 Error messages
Severity
WARNING
SEC-1032
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1033
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1034
Message
Probable Cause
Indicates that the input list has an invalid member.
<timestamp>, [SEC-1032], <sequence-number>,, ERROR, <system-name>,
Empty FCS list is not allowed.
<timestamp>, [SEC-1033], <sequence-number>,, ERROR, <system-name>,
The * symbol is only used to create the policy. Command terminated
<timestamp>, [SEC-1034], <sequence-number>,, ERROR, <system-name>,
Invalid member <policy member>.