HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 317
SEC-1029
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1030
Message
Probable Cause
Indicates that there has been a corruption during the distribution of the security database. This can only
occur when the primary FCS is distributing the security database to the other switches in the fabric and
local validation finds that there is an error in the security database. This is a rare occurence.
Recommended Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database might not be correctly updated for that specific
switch.
Severity
ERROR
SEC-1031
Message
Probable Cause
The security database size is not supported by the standby CP.
Recommended Action
Reduce the database size by reducing the security policy size.
<timestamp>, [SEC-1029], <sequence-number>,, ERROR, <system-name>,
Invalid character in <policy name>.
<timestamp>, [SEC-1030], <sequence-number>,, ERROR, <system-name>,
The length of the name invalid.
<timestamp>, [SEC-1031], <sequence-number>,, WARNING,
<system-name>, Current security policy DB cannot be supported by
standby. CPs will go out of sync.