HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 305
Probable Cause
Indicates that the RCS feature has been enabled. RCS must be capable on all switches in the fabric to be
enabled. If all switches are capable, it is automatically enabled.
Recommended Action
No action is required.
Severity
INFO
RCS-1003
Message
Probable Cause
Indicates that the specified RCS function failed to allocate memory.
Recommended Action
This message is usually transitory. Wait a few minutes and retry the command.
Check memory usage on the switch using the memShow command.
Reboot or power cycle the switch.
Severity
ERROR
RCS-1004
Message
Probable Cause
Indicates that a specified application did not register with RCS.
Recommended Action
Run the haShow command to view the HA state.
Run the haDisable and the haEnable commands.
Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS
v2.6, v3.1 and greater, v4.1 and greater.
Run the firmwareDownload command to upgrade the firmware for any switches that do not support
RCS.
Severity
ERROR
<timestamp>, [RCS-1003], <sequence-number>,, ERROR, <system-name>,
Failed to allocate memory: (<function name>)
<timestamp>, [RCS-1004], <sequence-number>,, ERROR, <system-name>,
Application(<application name>) not registered.(<error string>)