HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

292 Error messages
Probable Cause
Indicates that the name server on the standby CP has lower supported capability than the active CP due to
different firmware versions running on the active and standby CPs. This means that the active and standby
CPs are out of sync. Any execution of the haFailover or firmwareDownload commands will be
disruptive.
Recommended Action
To avoid disruption of traffic in the event of an unplanned failover, schedule a firmwareDownload so
that the active and standby CPs have the same firmware version.
Reduce the local device count to follow the capability of the lowest version of firmware.
Severity
INFO
PDM Error Messages
PDM-1001
Message
Probable Cause
Indicates that the PDM process could not parse the configuration file. This might be caused by a missing
configuration file during the installation.
Recommended Action
Run the firmwareDownload command to reinstall the firmware.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
PDM-1002
Message
Probable Cause
Indicates that the PDM process could not initialize the IPC mechanism.
Recommended Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
<timestamp>, [PDM-1001], <sequence-number>,, WARNING,
<system-name>, Failed to parse the pdm config
<timestamp>, [PDM-1002], <sequence-number>,, WARNING,
<system-name>, ipcInit failed