HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 287
Run the fabricShow command or the secFabricShow command to verify that the number of domains
matches the Management Server known domains.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
INFO
MS-1004
Message
Probable Cause
Indicates that MS detected an unstable count of domains in its own local resource. This message is often
transitory. The fabric might be reconfiguring, forming, or merging.
Recommended Action
Wait a few minutes and try the operation again.
Run the fabricShow command or the secFabricShow command to verify that the number of domains
matches the Management Server known domains.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
INFO
MS-1005
Message
Probable Cause
Indicates that MS received an invalid common transport (CT) response from switch domain. MS expects
either a CT accept IU or a reject IU; MS received neither response, which violates the Fibre Channel
Generic Services (FS-GS) specification.
Recommended Action
Check the integrity of the FC switch at the specified domain. It is not sending correct MS information as
defined by the FC-FS standard.
Severity
ERROR
<timestamp>, [MS-1004], <sequence-number>,, INFO, <system-name>, MS
detected ONLY 1 Domain(d=<domain in local resource>).
<timestamp>, [MS-1005], <sequence-number>,, ERROR, <system-name>,
MS Invalid CT Response from d=<domain>