HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

286 Error messages
Probable Cause
The MS platform service is unstable.
The <message string> can be one of the following:
• <No Resp for GCAP from>
The switch did not respond to a request for GCAP (MS Get Capabilities) command.
Recommended Action: No action is required.
• <GCAP sup but not PL by>
The GCAP (MS Get Capabilities) is supported but the flag for MS platform service is not set.
Recommended Action: Set the flag for the MS Platform Service.
• <GCAP Rejected (reason =BUSY) by>
The GCAP (MS Get Capabilities) is not supported by another switch.
Recommended Action: Upgrade the firmware level on the switch to a level that supports RCS.
• <Reject EXGPLDB from>
The request to the exchange platform database was rejected. The remote switch might be busy.
Recommended Action: Wait a few minutes and try the command again.
The <domain number> is the target domain that caused error.
Recommended Action
The recomended actions are as follows:
• <No Resp for GCAP from>
No action is required.
• <GCAP sup but not PL by>
Set the flag for the MS Platform Service.
• <GCAP Rejected (reason =BUSY) by>
Run the firmwareDownload command to upgrade the firmware level on the switch to a level that
supports RCS. RCS is supported in Fabric OS v2.6, v3.1 and greater, and v4.1 and greater.
• <Reject EXGPLDB from>
Wait a few minutes and try the command again.
Severity
INFO
MS-1003
Message
Probable Cause
Indicates that MS detected an unstable fabric; the command or operation might not be successfully
completed. This message is often transitory. The fabric might be reconfiguring, forming, or merging.
The message string can be one of the following:
• <DOMAIN_INVALID for a req from>
The domain is invalid for a request.
• <No WWN for>
Unable to acquire the World Wide Name (WWN) for the corresponding domain.
The domain number is the target domain that caused error.
Recommended Action
Wait a few minutes and try the operation again.
<timestamp>, [MS-1003], <sequence-number>,, INFO, <system-name>, MS
detected Unstable Fabric(<message string><domain number>).