HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 281
Run the saveCore command to FTP core files to a server location. It is normal behavior if there are no
core files to transfer.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
CRITICAL
LSDB Error Messages
LSDB-1001
Message
Probable Cause
Indicates that the link state database ID is out of the acceptable range. The valid link state ID is the same
as the valid domain ID, whose range is from 1 through 239. The switch will discard the record because it is
not supported.
Recommended Action
No action is required.
Severity
ERROR
LSDB-1002
Message
Probable Cause
Indicates that the local link state database reached the maximum incarnations.
An "incarnation" is a progressive number that identifies the most recent version of the LSR (link state
record). The switch generates its local link state record when first enabled.
Recommended Action
No action is required. The incarnation count will begin again at 0x80000001 after reaching 0x7FFFFFFF.
Severity
INFO
LSDB-1003
Message
<timestamp>, [LSDB-1001], <sequence-number>,, ERROR, <system-name>,
Link State ID <link state ID> out of range
<timestamp>, [LSDB-1002], <sequence-number>,, INFO, <system-name>,
Local Link State Record reached max incarnation#
<timestamp>, [LSDB-1003], <sequence-number>,, CRITICAL,
<system-name>, No database entry for local Link State Record,
domain <local domain>