HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 277
HLO-1003
Message
Probable Cause
Indicates that the HLO message received was invalid and the frame was dropped. The HP StorageWorks
switch will not accept FSPF frames from the remote switch.
The switch has received an invalid HLO because either the domain or port number in the HLO message has
an invalid value. This error can only occur when the HP StorageWorks switch is connected to a switch from
another manufacturer.
Recommended Action
The HLO message of the remote switch must be compatible with the value specified in the FSPF protocol.
Refer to the documentation of the other manufacturer's switch to change this value.
Severity
ERROR
HMON error messages
HMON-1001
Message
Probable Cause
Indicates that there was a problem reading the configuration file from the nonvolatile storage device. This
could be the result of a missing file or a corrupt file system.
The failure description is “configuration file error”.
Recommended Action
Run the firmwareDownload command to reinstall the firmware to your switch.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
CRITICAL
HTTP error messages
HTTP-1001
Message
<timestamp>, [HLO-1003], <sequence-number>,, ERROR, <system-name>,
Invalid Hello received from port <port number>, Domain = <domain
ID>, Remote Port = <remote port ID>
<timestamp>, [HMON-1001], <sequence-number>,, CRITICAL,
<system-name>, <Failure description>
<timestamp>, [HTTP-1001], <sequence-number>,, INFO, <system-name>,
Switch PIDformat has changed to <current PID format>.