HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

258 Error messages
• Processor rebooted - Fastboot
• Processor rebooted - Giveup Master:SYSM
• Processor rebooted - CP Faulty:SYSM
• Processor rebooted - FirmwareDownload
• Processor rebooted - ConfigDownload:MS
• Processor rebooted - ChangeWWN:EM
• Processor rebooted - Reboot:WebTool
• Processor rebooted - Fastboot:WebTool
• Processor rebooted - Software Fault:Software Watchdog
• Processor rebooted - Software Fault:Kernel Panic
• Processor rebooted - Software Fault:ASSERT
• Processor rebooted - Reboot:SNMP
• Processor rebooted - Fastboot:SNMP
• Processor rebooted - Reboot
• Processor rebooted - Chassis Config
• Processor rebooted - Reboot:API
• Processor rebooted - Reboot:HAM
• Processor rebooted - EMFault:EM
Recommended Action
Check the error log on both CPs for additional messages that might indicate the reason for the reboot.
Severity
INFO
HAMK error messages
HAMK-1002
Message
Probable Cause
Indicates that the active CP blade determined that the standby CP blade is down. This might happen as a
result of an operator-initiated action such as firmwareDownload, if the standby CP blade is reset or
removed, or as a result of an error in the standby CP blade.
Recommended Action
Monitor the standby CP blade for a few minutes. If this message is due to a standby CP reboot, the
message HAMK-1003 will display after the standby CP has completed the reboot successfully.
If the standby CP does not successfully connect to the active CP after 10 minutes, reboot the standby CP
blade by ejecting the blade and reseating it.
Severity
INFO
<timestamp>, [HAMK-1002], <sequence-number>,, INFO, <system-name>,
Heartbeat down