HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 257
HAM error messages
HAM-1001
Message
Probable Cause
Indicates that a standby CP device error is reported by the high-availability manager (HAM) Health
Monitor, with a specific device and severity level. The severity level can be critical, major, or minor.
The active CP will continue to function normally, but because the standby CP is not healthy, nondisruptive
failover is not possible.
Recommended Action
Reboot the standby CP blade by ejecting the card and reseating it.
If the problem persists, replace the standby CP.
Severity
CRITICAL
HAM-1002
Message
Probable Cause
Indicates that all of the standby CP devices monitored by the HAM Health Monitor report no error.
Recommended Action
No action is required.
Severity
INFO
HAM-1004
Message
Probable Cause
This message records switch reboots that were not initiated by a user or by the firmwareDownload
command. Some examples of errors that might initiate this message are hardware errors, software errors,
compact flash errors, or memory errors. The possible values for <reboot reason> are:
• Processor rebooted - Hafailover
• Processor rebooted - Unknown
<timestamp>, [HAM-1001], <sequence-number>,, CRITICAL,
<system-name>, Standby CP is not Healthy, device <device name>
status BAD, severity = <severity>
<timestamp>, [HAM-1002], <sequence-number>,, INFO, <system-name>,
Standby CP is Healthy
<timestamp>, [HAM-1004], <sequence-number>,, INFO, <system-name>,
<Reboot Reason>