HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

218 Error messages
FW-1302
Message
Probable Cause
Indicates that the number of HTTP violations has risen above the high boundary. HTTP violations indicate
that a browser connection request has been received from an unauthorized IP address. The HTTP_POLICY
contains a list of TCP/IP addresses that are authorized to establish browser connections to the switches in
the fabric. The IP addresses use the standard "dot" notation (for example, 255.255.255.255).
Recommended Action
Run the errShow command to determine the IP address that sent the request. Responses to security-class
messages depend on user policies. Consult your security administrator for response strategies and policies.
Severity
WARNING
FW-1303
Message
Probable Cause
Indicates that the number of HTTP violations has changed from a value outside of the acceptable range to
a value within the acceptable range. HTTP violations indicate that a browser connection request has been
received from an unauthorized IP address. The HTTP_POLICY contains a list of TCP/IP addresses that are
authorized to establish browser connections to the switches in the fabric. The IP addresses use the standard
"dot" notation (for example, 255.255.255.255).
Recommended Action
No action is required.
Severity
INFO
FW-1304
Message
Probable Cause
Indicates that the number of API violations has changed. API violations indicate that an API connection
request has been received from an unauthorized IP address. The SNMP_POLICY contains a list of TCP/IP
<timestamp>, [FW-1302], <sequence-number>,, WARNING, <system-name>,
<Label>, is above high boundary(High=<High value>, Low=<Low
value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1303], <sequence-number>,, INFO, <system-name>,
<Label>, is between high and low boundaries(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1304], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.