HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 209
Severity
WARNING
FW-1219
Message
Probable Cause
Indicates that the number of CRC errors has changed from a value outside of the acceptable range to a
value within the acceptable range. This indicates that errors have been detected in the FC frame. Invalid
CRC messages occur when the number of CRC errors in Fibre Channel frames for specific source ID (S_ID)
and destination ID (D_ID) pairs change. These messages might also be caused by dirty equipment,
temperature fluctuations, and aging equipment. You should set your high boundaries to five- or six-digit
figures, as only large numbers of messages indicate a problem in this area.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
INFO
FW-1240
Message
Probable Cause
Indicates that the number of EE CRC errors has changed. Invalid CRC messages occur when the number of
CRC errors in Fibre Channel frames for specific source ID (S_ID) and destination ID (D_ID) pairs change.
These messages might also be caused by dirty equipment, temperature fluctuations, and aging equipment.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
INFO
FW-1241
Message
<timestamp>, [FW-1219], <sequence-number>,, INFO, <system-name>,
<Label>, is between high and low boundaries(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1240], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
<timestamp>, [FW-1241], <sequence-number>,, INFO, <system-name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.