HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

194 Error messages
FW-1140
Message
Probable Cause
Indicates that the number of SFP state changes has changed from a value outside of the acceptable range
to a value within the acceptable range. SFP state changes occur when the SFP is inserted or removed.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
INFO
FW-1160
Message
Probable Cause
Indicates that the number of link failures that the port experiences has changed. Link loss errors occur when
a link experiences a loss of signal and fails. Both physical and hardware problems can cause link loss
errors. Link loss errors frequently occur due to a loss of synchronization. Check for concurrent loss of
synchronization errors and, if applicable, troubleshoot them.
Recommended Action
Check both ends of your cable connection. Verify that the cable and SFPs are not faulty.
Losses of synchronization commonly causes link failures. If you receive concurrent loss of synchronization
errors, troubleshoot the loss of synchronization.
Severity
INFO
FW-1161
Message
Probable Cause
Indicates that the number of link failures that the port experiences has fallen below the low boundary. Link
loss errors occur when a link experiences a loss of signal and fails. Both physical and hardware problems
<timestamp>, [FW-1140], <sequence-number>,, INFO, <system-name>,
<Label>, is between high and low boundaries(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1160], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, value has changed(High=<High value>, Low=<Low
value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1161], <sequence-number>,, INFO, <system-name>,
<Port Name>, <Label>, is below low boundary(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.