HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 183
Probable Cause
Indicates that the value of the SFP voltage has changed from a value outside of the acceptable range to a
value within the acceptable range.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
INFO
FW-1113
Message
Probable Cause
Indicates that the number of times E_Ports have gone down has changed. E_Ports go down each time you
remove a cable or SFP. SFP failures also cause E_Ports to go down. E_Port downs might be caused by
transient errors.
Recommended Action
Check both ends of the physical connection and verify that the SFPs and cables are functioning properly.
Severity
INFO
FW-1114
Message
Probable Cause
Indicates that the number of times E_Ports have gone down has fallen below the low boundary. E_Ports go
down each time you remove a cable or SFP. SFP failures also cause E_Ports to go down. E_Port downs
might be caused by transient errors.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation. A low number of E_Port failures means that the switch is functioning normally.
Severity
INFO
<timestamp>, [FW-1113], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
<timestamp>, [FW-1114], <sequence-number>,, INFO, <system-name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.