HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

180 Error messages
Recommended Action
Replace the SFP.
Severity
WARNING
FW-1044
Message
Probable Cause
Indicates that the transmit power value of the SFP has changed from a value outside of the acceptable
range to a value within the acceptable range. The transmit performance area measures the amount of
outgoing laser to help you determine if the SFP is in good working condition or not. If the counter often
exceeds the threshold, the SFP is deteriorating.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
Severity
INFO
FW-1045
Message
Probable Cause
Indicates that the value of the SFP voltage has changed.
Recommended Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation. If the supplied voltage of the SFP transceiver is outside of the normal range, this might indicate
a hardware failure. Frequent messages indicate that you must replace the SFP.
Severity
INFO
FW-1046
Message
<timestamp>, [FW-1044], <sequence-number>,, INFO, <system-name>,
<Label>, is between high and low boundaries(High=<High value>,
Low=<Low value>). Current value is <Value> <Unit>.
<timestamp>, [FW-1045], <sequence-number>,, INFO, <system-name>,
<Label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
<timestamp>, [FW-1046], <sequence-number>,, WARNING, <system-name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.