HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 171
FSSM-1003
Message
Probable Cause
Indicates that the HA state for the active CP is out of synchronization with the HA state of the standby CP. If
the active CP failover occurs when the HA state is out of sync, the failover is disruptive.
Recommended Action
If this message was logged as a result of a user-initiated action (such as running the switchReboot
command), then no action is required.
Otherwise, issue the haSyncStart command on the active CP and try resynchronizing the HA state.
If the HA state does not become synchronized, run the haDump command to help diagnose the problem.
If the message persists, run supportFtp and traceFtp -e (as needed) to set up automatic FTP transfers;
then run the supportSave command and contact your switch service provider.
Severity
WARNING
FSSM-1004
Message
Probable Cause
Indicates that the active CP and the standby CP in a dual CP system are running firmware that are
incompatible with each other. If the active CP fails, the failover will be disruptive. In a pizza box system,
this message is logged when firmware upgrade/downgrade was invoked. The new firmware version is not
compatible with current running version. This cause a disruptive firmware upgrade/downgrade
Recommended Action
For a dual CP system, run the firmwareDownload command to load compatible firmware on the
standby CP. For details on this command, refer to the
HP StorageWorks Fabric OS 5.x command reference
guide
.
Severity
INFO
FW error messages
FW-1001
Message
<timestamp>, [FSSM-1003], <sequence-number>,, WARNING,
<system-name>, HA State out of sync
<timestamp>, [FSSM-1004], <sequence-number>,, INFO, <system-name>,
Incompatible software version in HA synchronization.
<timestamp>, [FW-1001], <sequence-number>,, INFO, <system-name>,
<label>, value has changed(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.