HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

164 Error messages
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FICU-1008
Message
Probable Cause
Indicates that the specified port was disabled when the switch was enabled for FICON Management
Server mode (fmsmode). This was due to a port address conflict.
Recommended Action
No action is required.
Severity
WARNING
FICU-1009
Message
Probable Cause
Indicates that the frame filtering resources required to enable FICON Management Server mode (fmsmode)
were not available on some of the ports.
Recommended Action
Use the perfDelFilterMonitor command to delete the filter-based performance monitors used on all
ports to free up the resources.
Severity
WARNING
FICU-1010
Message
Probable Cause
Indicates that the FICON Management Server mode (fmsmode) was not enabled because the specified
port has an address conflict with the CUP management port.
<timestamp>, [FICU-1008], <sequence-number>,, WARNING,
<system-name>, FMS mode has been enabled. Port:<port number> has
been disabled due to port address conflict.
<timestamp>, [FICU-1009], <sequence-number>,, WARNING,
<system-name>, FMS Mode enable failed due to insufficient frame
filtering resources on some ports
<timestamp>, [FICU-1010], <sequence-number>,, WARNING,
<system-name>, FMS Mode enable failed due to address conflict with
port <port number>.