HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

162 Error messages
Probable Cause
Indicates that the FICON-CUP daemon failed to get switch RNID from the management server due to a
Fabric OS problem. The domain variable displays the domain ID of the target switch for this RNID. The
error variable is an internal error number.
Recommended Action
If this is a bladed switch, execute the haFailover command. If the problem persists, or if this is a
nonbladed switch, download a new firmware version using the firmwareDownload command. Refer
to the
HP StorageWorks Fabric OS 5.x command reference guide for more information on this command.
Severity
ERROR
FICU-1003
Message
Probable Cause
Indicates that the FICON-CUP license is not installed on the switch.
Recommended Action
Run the licenseShow command to check the installed licenses on the switch. The switch cannot be
managed using FICON-CUP commands until the FICON-CUP license is installed. Contact your switch
supplier for a FICON-CUP license. Run the licenseAdd command to add the license to your switch.
Severity
WARNING
FICU-1004
Message
Probable Cause
Indicates that a PID format conflict was encountered. The core PID format is required for FICON-CUP.
The pid_format variable displays the PID format currently running on the fabric:
• 0 is VC-encoded PID format
• 1 is core PID format
• 2 is extended-edge PID format
FMS mode displays whether FICON Management Server mode is enabled; a 0 means this mode is
enabled and a 1 means this mode is disabled.
Recommended Action
For FICON Management Server mode (fmsmode) to be enabled, the core PID format must be used in the
fabric. Change the PID format to core PID using the configure command and reenable fmsmode using
ficoncupset command. Refer to the
HP StorageWorks Fabric OS 5.x administrator guide for information
<timestamp>, [FICU-1003], <sequence-number>,, WARNING,
<system-name>, <function name>: <message> FICON-CUP License Not
Installed (<error>)
<timestamp>, [FICU-1004], <sequence-number>,, WARNING,
<system-name>, <function name>: Failed to set FMS mode: conflicting
PID Format:<pid_format>, FMS Mode:<mode>