HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 161
Severity
WARNING
FICU-1009
Message
Probable Cause
Indicates that the frame filtering resources required to enable FICON Management Server mode (fmsmode)
were not available on some of the ports.
Recommended Action
Use the perfDelFilterMonitor command to delete the filter-based performance monitors used on all
ports to free up the resources.
Severity
WARNING
FKLB error messages
FICU-1001
Message
Probable Cause
Indicates that one of the configuration management functions failed. The key variable is part of the Fabric
OS configuration database and is for support use only. The error variable is an internal error number.
Recommended Action
Execute an haFailover on the switch if it has redundant CPs or reboot the switch. Run the saveCore
command to check if your flash is full. If the flash is full, run the saveCore command to clear the core
files. Refer to the
HP StorageWorks Fabric OS 5.x command reference guide for more information on these
commands.
Severity
ERROR
FICU-1002
Message
<timestamp>, [FICU-1009], <sequence-number>,, WARNING,
<system-name>, FMS Mode enable failed due to insufficient frame
filtering resources on some ports
<timestamp>, [FICU-1001], <sequence-number>,, ERROR, <system-name>,
<function name>: config<config Set(key)|Get(key)| Save> failed rc =
<error>
<timestamp>, [FICU-1002], <sequence-number>,, ERROR, <system-name>,
Failed to get RNID from Management Server Domain=<domain>
rc=<error>