HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

160 Error messages
FICU-1006
Message
Probable Cause
Indicates that the path with the specified PID and channel image ID lost allegiance to a FICON-CUP
device.
Recommended Action
Check if the FICON channel corresponding to the PID in the message is functioning correctly.
Severity
WARNING
FICU-1007
Message
Probable Cause
Indicates that memory resources are low. This might be a transient problem.
Recommended Action
If the message persists, check the memory usage on the switch, using the memShow command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FICU-1008
Message
Probable Cause
Indicates that the specified port was disabled when the switch was enabled for FICON Management
Server mode (fmsmode). This was due to a port address conflict.
Recommended Action
No action is required.
<timestamp>, [FICU-1006], <sequence-number>,, WARNING,
<system-name>, Control Device Allegiance Reset (Logical Path:
0x<PID>:0x<channel image ID>)
<timestamp>, [FICU-1007], <sequence-number>,, WARNING,
<system-name>, <function name>: Failed to allocate memory while
performing <message>
<timestamp>, [FICU-1008], <sequence-number>,, WARNING,
<system-name>, FMS mode has been enabled. Port:<port number> has
been disabled due to port address conflict.